Specifications

19
Hints and Tips
Problem Possible Solutions
My hob burner does
not light
• Check the cooker is switched on.
• Check the gas supply valve is turned on and the supply to the house is working. You
should hear the gas when you press and turn a burner control on.
• The ignitors may be dirty. Clean them gently with a small nylon brush such as a
toothbrush.
• The burner parts may not be located properly. Check the assembly and make sure
the burner cap is sitting at.
My burner ames are
yellow or hard to start
• The burner parts may not be located properly. Check the assembly and make sure
the burner cap is sitting at.
• If you use bottled gas this may indicate you are getting near the end of the bottle.
• Check the burner parts are clean and dry.
• The gas pressure may not be at the correct level.
• Check with your approved service agent.
• Your cooker may not be set up for the gas you are using. Check this with your
approved service agent.
One of my burners
has an uneven ame
• Check the burner parts are clean and dry. Check the assembly and make sure the
burner cap is sitting at.
My burner goes out
when I let go of the
control
• 'Flame supervision Device (FSD)' is operating. Hold in the control for approximately
10 seconds after the burner has lit. Releasing the control too soon will extinguish
the ame.
The ame goes out at
low settings
• The gas supply pressure may be low. Check this with your approved service agent.
• The low setting may have been adjusted incorrectly.
• Check this with your approved service agent.
My burners do not
turn down much
(when running on
bottled gas or LPG)
• Your burners may not have been adjusted correctly. Check this with your approved
service agent.
The ame tips are very
yellow
• Call your approved service agent.
There are
objectionable odours
• During rst time use, a small amount of smoke or odours will be noticeable from
the Oven or Grill. This is the protection to prevent corrosion burning o. It should
disappear after approximately 15 minutes.
• Call your approved service agent.
The ame appears to
lift o the burner
• Call your approved service agent.
There is an electricity
failure
• If there is an electricity failure, you can still use your cooker. Light the burners by
holding a candle lighter close to the side of the burner and turning the controls
to the High position. Wait until the ame is burning evenly before adjusting. The
control must still be held in for 10 seconds after the burner has lit. Releasing the
control too soon will extinguish the ame.
CFSGWH_SV12_IB_120607_Annie.indd 19 12年6月7日 下午7:15