Specifications

7
Using the Hob Burners
1. Choose the control for the burner you want to use.
2. Press the
Ignition switch and at the same time press and hold the Burner control in and then turn it anti-
clockwise to the maximum position. Release the Ignition switch only, once the burner is lit.
Continue to hold the control in for approximately 10 seconds after the burner has lit. Releasing the control
too soon will extinguish the ame due to the ame failure safety feature.
Manual Ignition (in case of electricity failure)
To ignite one of the burners, press and turn the control anti-clockwise so that the control is at the
positions. Hold an ignition source (e.g. candle lighter, spark ignitor) close to the upper circumference of the
burner. Move the ignition source away as soon as you see a stable ame. Continue holding the control in for
approximately 10 seconds after the burner has lit. Releasing the control too soon will extinguish the ame
due to the ame failure safety feature.
3. The control has 3 positions: OFF (O), maximum
and minimum . After you have ignited the burner at
the maximum position , you should adjust the ame length for cooking between the maximum and
minimum ame positions. You must not cook with the control between the maximum and OFF (O)
positions.
4. After ignition, check the ames visually. If you see yellow tipped, lifted or unstable ames; turn the control
o, and check the assembly (once the parts have cooled suciently) of the burner rings and caps. Also,
make sure that no liquid has entered into the burner cups. If the burner ames go out accidentally, turn the
burners o, and do not try to light them again for at least 90 seconds (to allow the gas to disperse).
5. When turning the hob o, turn the control in a clockwise direction so that the control shows the OFF (O)
position in line with the marking on the control panel.
Flame Failure Safety Feature
The ame supervision device (FSD) probe cuts o the gas supply to the burner if the ame is blown out.
When lighting the burner, hold the control in for approximately 10 seconds after the burner has lit. Releasing the
control too soon will extinguish the ame.
If the ames are accidentally extinguished, turn o the burner and do not try to light it again for at least 90
seconds (to allow the gas to disperse).
• If the burner does not light within 15 seconds, turn the control o and wait for at least 90 seconds
before trying again.
• To switch the burner o, turn the control clockwise to the OFF (O) position.
• After use, always turn the controls to the OFF (O) position.
This appliance is for cooking purposes only. It must not be used for other purposes, for example
room heating.
CFSGWH_SV12_IB_120607_Annie.indd 7 12年6月7日 下午7:14