Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
CARRIAGE BOLT1/2-13 x 1 3/441
.188 x 1.00 x 3.00" SQUARE HOLE SPACERCM-SP4022
HEX FLANGE NUTHFN 121343
.188 x 1.25 x 1.25 SPACERCM-SP11324
FISHWIRE TOOL1/2"15
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
- NO DRILLING REQUIRED
- FISHWIRE HARDWARE
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
23
10
00-02 PLYMOUTH NEON & 00-05 DODGE NEON
10/5/2012
11039
20
3
1. Fishwire a 1/2" carriage bolt and CM-SP113 spacer into the rearmost round hole in each frame rail
using the oval access hole. Fishwire a 1/2" carriage bolt and CM-SP40 square hole spacer into the
oval hole in each frame using the oval access hole. (See Fishwire Techinique.)
2. Raise the hitch into position against the frame rails, aligning the fishwired hardware with the slots
in the hitch side plates. Secure the hitch to the vehicle using (4) hex flange nuts as shown.
(Take care not to push the fishwired hardware into frame rails.)
3. Torque all hardware to 110 ft-lbs.
1
2
(EXCEPT R/T, ACR, SRT-4 & MAGNUM)
24678/ 247367
4
5
DRIVER SIDE PLATE
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
PASSENGER
SIDE PLATE
ACCESS HOLE
(BOTH SIDES)
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501