Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Mark and trim heat shield. Reattach heat shield using fasteners
removed in Step (2).
NOTE: DIMENSIONS ARE
APPROXIMATE, CONFIRM
FIT PRIOR TO TRIMMING
2.00 in
4. Fishwire 7/16-14 x 1 1/4" carriage bolt and SP11 spacer through
the rear most hole in the frame and out the next hole towards the
front, both sides.
5. Reverse fishwire 7/16-14 x 1 1/4" carriage bolt and SP11 spacer
into the rear most hole, both sides.
6. Raise hitch over the exhaust and slide it past the exhaust hanger.
Secure hitch using 7/16-14 flange nuts. Note: When raising
hitch into position you may have to push bolts part way back into
the frame to get the plates into position. You may use fishwires
to guide hitch during mounting to prevent the loss of bolts and
spacers inside the frame rails.