Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
NUT,SER-FLANGE,3/8-16 UNC,GRD8,YZ
20-0010241
HHCS,3/8-16 UNC,1-1/2,GRD8,YZ10-1023442
WASHER,FDR,3/8,CZ30-0020543
NUT,SER-FLANGE,7/16-14 UNC,GRD8,YZ20-001031
4
BOLT,CAR,7/16-14 UNC,3-1/2,GRD8,ZP
10-1056315
.250 x 1.50 x 3.00" SQUARE HOLE SPACERCM-SP416
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
16
45
00-05 PASSAT SEDAN & WAGON
12/30/2020
11076 / 247382
DRILLING REQUIRED
1) Clear tire well of contents for drilling. Trim bumper fascia away from top of tow loop area for installation.
2) Place hitch on top of tow loop with hitch side plates resting against sides of tire well. Install fastener in
tow strap as shown. Do not tighten.
3) Level hitch to vehicle. Mark and center punch tire well using hitch as a template. Remove hitch and drill holes.
4) Place hitch on vehicle and install hardware as shown.
5) Torque all 7/16" fasteners to 70 lb.-ft. and all 3/8" fasteners to 45 lb.-ft.
TIRE WELL
TOW LOOP
FOUR DRILLED HOLES
1
5
2
3
4
6
DESIGNED FOR USE WITH
BALL MOUNT # D 55001