Owners manual
Parts List
DESCRIPTIONPART NUMBERQTYITEM
CARRIAGE BOLT7/16 - 14 x 1 3/4
21
.250 x 1.00 x 2.50" SQUARE HOLE SPACERCM-SP11
22
HELICAL LOCK WASHER7/16 LOCK WASHER
23
HEX NUT7/16-1424
HEX BOLT3/8-16 X 1 1/235
WASHER3/8"36
LOCK WASHER3/8"3
7
HEX NUT3/8 - 1638
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
26
60
06-07 BMW 530XI WAGON
11/30/2012
11182
1) Remove or elevate floor panels inside trunk/rear
compartment and clear contents of tire well.
Note two holes will be drilled on outside of rails running to front/back of vehicle.
(Disregard step 2 to if you have a right-angle drill.)
2) In rear tire wells locate and remove two clips, gravel shield, three plastic pin fasteners
per side. Slide bumper assembly with fascia off to the rear.
3) Carefully locate center of vehicle and mark. Position hitch as shown with rear bracket
snug under body ledge and hitch receiver exactly centered on vehicle. Use hitch as
template to mark body five places for drill locations.
4) Center punch and drill car two places for 7/16" diameter bolts and three places for 3/8"
diameter bolts. Apply silicon around holes to prevent exhaust fumes from entering vehicle.
Place bolts and flat washers on inside of vehicle with lock washers and nuts on outside of vehicle.
(Washers may have to conform to panel upon tightening.)
5) Torque all 3/8"-16 hardware to 45 lb-ft. and all 7/16"-14 hardware to 70 lb-ft.
1
2
3
4
5
6
7
8
SPARE TIRE WELL
- DRILLING REQUIRED
DESIGNED FOR USE WITH
BALL MOUNT # D-55010