Owners manual

HEAT SHIELD TRIM DETAIL
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
35
45
AUDI A4 AVANT, AUDI ALLROAD, AUDI A4 SEDAN
10/15/2012
11195
90
PAGE 1 OF 2
Parts List
DESCRIPTIONPART NUMBERQTYITEM
1/2" FISHWIRE1_2 FISHWIRE
21
HEX FLANGE NUTHFN 121342
.250 x 1.00 x 3.00" SQUARE HOLE SPACERCM-SP6
43
CARRIAGE BOLT1/2-13 x 1 1/2
44
WASHER7/16 WASHER2
5
HEX BOLTM10 - 1.5 x 110 HEX26
CONICAL TOOTHED WASHER7/16"27
Hex NutM10 - 1.50 HEX-NUT28
- NO DRILLING REQUIRED
- LOWER EXHAUST
- HEAT SHIELD TRIMMING REQUIRED
EXISTING WELDNUT HOLES
TRIMMED ACCESS HOLE
CENTER PUNCHED HOLE
EXISTING HOLE
EXISTING EXHAUST
BRACKET HOLES
HEAT SHIELD
5.00 in
APPROXIMATE
EXISTING FASTENER
(BOTH SIDES)
DRIVER SIDE
FRAME RAIL
EXISTING FASTENER
(BOTH SIDES)
4
3
7
8
6
5
1
2
ACCESS HOLE
(BOTH SIDES)
MUFFLER
MUFFLER
TIE DOWN LATCH
(BOTH SIDES)
INTERIOR SIDE RAIL
(BOTH SIDES)
PASSENGER SIDE
FRAME RAIL
ALUMINUM BUMPER
BRACKET (BOTH SIDES)
29137
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501