Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLT1/2-13 x 1 3/411
LOCK WASHER1/2"12
HEX NUT
1/2-13
13
HEX BOLT
M10 - 1.25 x 40 HEX24
WASHER3/8"25
HELICAL LOCK WASHER7/16 LOCK WASHER
26
.250 x 1.50 x 3.50" ROUND HOLE SPACERCM-SP511
7
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
22
45
2001-2005 HYUNDAI XG300 & XG350
11/12/2012
11228
90
247416
1. This hitch mounts to the bottom of the right and left frame rails; one threaded hole each side, and to the tow loop
located on the car's trunk pan.
2. Temporarily lower the muffler/tail pipe by disconnecting the two rearmost hangers if necessary.
3. Lift the hitch into position on the bottom of the frame rails, as shown in the diagram, Install as shown. Do not fully
tighten.
4. Fasten the hitch to the tow loop using fasteners as shown. The backing plate fits to the top of the loop and the hitch
bracket fits under the loop.
5. Torque all 1/2" fasteners to 110 lb-ft, and all 10mm fasteners to 48 lb-ft.
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
TOW LOOP
1
5
6
4
2
3
-NO DRILLING REQUIRED
-LOWER EXHAUST
7
EXISTING WELD NUT
(BOTH SIDES)
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501