Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
CARRIAGE BOLT7/16-14 x 1 1/241
HELICAL LOCK WASHER7/16 LOCK WASHER
42
HEX NUT7/16-1443
HEX BOLT3/8 - 16 x 1 3/414
HEX BOLT3/8 - 16 x 1 1/43
5
LOCK WASHER3/8"46
HEX NUT
3/8 - 16
47
.250" TAIL BRACKETCM-11237-TB
18
7/16 " FISHWIRE TOOLCM-438-FW19
2.00 X 0.88 X .125 SPACERCM-SP108410
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
15
45
95-98 MAZDA PROTEGE SEDAN
12/5/2012
11237
90
24604 / 247269
1
6
7
2
3
5
4
8
1. This hitch mounts to the bottom of the bumper, and to the bottom of the spare tire well.
2. Temporarily remove the spare tire and clear the tire well. Remove two phillips fascia screws on the bumper.
3. Lift the hitch into position on the car and check for center. Using the hitch as a template, drill the bumper and spare tire
well for fasteners as shown.
4. Using the fishwire method, Install fasteners as shown. Access is from the bumper ends. Also, install fasteners as
shown in spare tire well.
5. Torque all 3/8" fasteners to 45 lb-ft, and all 7/16" fasteners to 70 lb-ft.
SPARE TIRE WELL
BUMPER BEAM
DRILLING REQUIRED
9
10
DESIGNED FOR USE WITH
BALL MOUNT # D-55003 / 45503