Owners manual

ManualsBrandsCurt ManualsAutomotiveCURT 11238 Class I 1.25 in. Receiver Hitch Fits 98-05 GS300 GS400 GS430

Parts List

DESCRIPTIONPART NUMBERQTYITEM

HEX BOLT

M12 - 1.25 x 40 HEX61

CONICAL TOOTHED WASHER1/2"62

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***

WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.

** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813

HITCH WEIGHT:

LBS.

INSTALL TIME

PROFESSIONAL: MINUTES

NOVICE (DIY): MINUTES

INSTALL NOTES:

INSTALLATION STEPS

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS

ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

2,500 250

98-05 LEXUS GS 300, 98-00 GS 400, 01-05 GS 430

11/12/2012

11238

257243

PASSENGER SIDE

FRAME RAIL

EXISTING WELDNUTS

(BOTH SIDES)

TIE DOWN BRACKET

(BOTH SIDES)

-NO DRILLING REQUIRED

-TEMPORARILY REMOVE TIE

DOWN BRACKETS

1. Temporarily unbolt tie down brackets from chassis on both sides of car. Temporarily unfasten the fascia

tabs attached to tire well.

2. Position the hitch on car aligning slots in hitch with weldnuts in chassis. Remount tie down brackets

sandwiching hitch between chassis and tie down brackets. Install fasteners as shown.

3. Torque all hardware to 86 lb.-ft.

DRIVER SIDE

FRAME RAIL

DESIGNED FOR USE WITH

BALLMOUNT #55001 / 45501