Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLT3/8-16 X 1 1/2
41
HEX FLANGE NUTHFN381642
HEX BOLT7/16-14 x 1 1/223
HEX FLANGE NUT7/16-1424
.250 x 1.50 x 1.50" ROUND HOLE SPACERCM-SP221
5
FENDER WASHER3/8"26
.25 x 4.00" SPACERCM-11242-SP17
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2000 200
17
45
11242 / 247363 98-04 KIA SEPHIA 00-04 KIA SPECTRA
10/15/2012
1) Temporarily remove spare tire. Raise hitch into position, with receiver tube centered left to right on
vehicle and rearmost mounting strap against rear panel lip.
2) With hitch in position, use hitch as template and drill four holes for fasteners. Loosely install fasteners
as shown.
3) Using reinforcement plate as template, drill two holes for fasteners into rear panel lip. Install fasteners
as shown into rear surface of tire well.
4) Torque all 7/16" fasteners to 70 lb.-ft. and all 3/8" fasteners to 45 lb.-ft. Replace spare tire.
DRILLING REQUIRED
4
2
7
1
3
1
6
2
5
TIRE WELL
MOUNTING STRAP
REAR PANEL LIP
DESIGNED FOR USE WITH
BALL MOUNT # D-20 / 45520