Owners manual
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HANDLE NUT1/2-1311
U-BOLT7_16 - 14 x 1.75" x 1.00" C-C12
HEX BOLT3/8-16 X 1 1/233
FENDER WASHER3/8"34
HEX BOLT1/2-13 x 1 1/4
15
CONICAL TOOTHED WASHER1/2"
16
CONICAL TOOTHED WASHER7/16"17
HEX FLANGE NUTHFN381638
HEX TAP BOLT7/16-14 x 2 1/219
NYLOCK HEX NUT7_16 - 14210
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
15
30
97-02 MITSUBISHI DIAMANTE SEDAN
12/5/2012
11244
60
247360
4
2
3
1
7
FRAME ACCESS SLOT
-REMOVE SPARE TEMPORARILY
-DRILLING REQUIRED
1. Position hitch on car and mount using fastener at rearmost hole in hitch bracket. Mount hitch at
car's tow loop using the u-bolt and nuts. Install fastener in forward hole of hitch bracket placing
1/2" handle nut through access hole just forward of hitch bracket.
2. Using the three hole bracket on hitch main body as a template, drill car's rear panel three places
for 3/8" bolts. Install fasteners making certain the large diameter 3/8" fender washers are
placed inside rear panel. It may be necessary to push the rear bumper fascia temporarily out
of the way to gain access to drill.
3. Torque: 1/2" bolts to 110 ft-lb., 7/16 to 70 ft-lb., M10 bolt to 48 ft-lb., 3/8" bolts to 45 ft-lb.
9
10
5
6
TOW LOOP
DRIVER SIDE FRAME RAIL
EXISTING WELDNUT
8
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501