Owners manual

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
7/16 " FISHWIRE TOOLCM-438-FW
11
HEX FLANGE NUT7/16-1422
HEX BOLTM10 - 1.25 x 3043
.188 x 1.00 x 3.00" SQUARE HOLE SPACERCM-SP40
24
CARRIAGE BOLT7/16-14 x 1 1/225
CONICAL TOOTHED WASHER3/8"46
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
25
30
89-94 NISSAN MAXIMA
11/13/2017
11253
60
257204
- NO DRILLING REQUIRED
EXISTING
WELD NUTS
(BOTH SIDES)
5
3
1
1. Remove tie down brackets from both frame rails under the car. From the passenger side also remove the
exhaust hanger bracket.
2. Lifting hitch into position, mount hitch to the car with the M10 bolts provided.
3. Using the fishwire tool, place the spacer and the 7/16" carriage bolts, into position inside the frame and
through the hole as shown. Redrilling this hole for alignment may be necessary before fishwiring the
fasteners.
4. Reattach exhaust reusing the cars hangers and the hanger rod provided on the hitch.
5. Tighten all 7/16" hardware to 70 lb-ft and all M10 hardware to 48 lb-ft.
EXHAUST
HANGER
1 GENERIC INSTRUCTION SHEET 8/9/2007 DWS
2
CURRENT STYLE, REPLACED 7/16" HEX NUT, LOCK WASHER AND FLAT WASHER WITH HEX FLANGE NUT, REPLACED 3/8" LOCK WASHER AND FLAT WASHER WITH CONICAL TOOTHED WASHER
12/1/2009 CJL
3
CHG TO GRADE 8 TORQUE SPECS
12/7/2012 AJP
4 UPDATED TOW RATING 11/13/2017 AGC
REVISION HISTORY
REV DESCRIPTION DATE APPROVED
6
2
4
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501