Owners manual

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
20
20
93-96 TOYOTA COROLLA WAGON
11/30/2012
11283
40
247245
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM12 - 1.25 x 25 HEX61
WASHER7/16 WASHER
62
LOCK WASHER1/2"
63
1. Under the rear of the vehicle, locate the box shape frame rails running front to back on the driver and
passenger sides. (3) existing 12mm weldnuts are on the outer vertical wall of the frame rails. Tie down
brackets may or may not be mounted at these weldnuts. If brackets are in place, remove them and
return them to the vehicle's owner for reinstallation should the hitch ever be removed. This hitch will
mount at these weldnuts using the fasteners provided with the hitch.
2. Position the hitch on the vehicle as shown in diagram by lining up the holes in the hitch side plates with the
12mm weldnuts in the vehicle's frame.
3. Fasten the hitch to the veihcle using fasteners as shown with flat and lock washers placed under the heads of
the bolts. Hitch cross tube should pass below the rear bumper fascia.
4. Torque all 12mm fasteners to 86 lb-ft.
- NO DRILLING REQUIRED
- REMOVE TIE DOWN BRACKETS
2
3
1
DRIVER SIDE
FRAME RAIL
EXISTING WELD NUTS
(BOTH SIDES)
PASSENGER SIDE
FRAME RAIL
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501