Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. It may be necessary to remove support strap to allow
exhaust to hang lower and allow heat shield to be fully
removed. It will be necessary to gently pull fascia
downward to allow muffler pegs to be below fascia.
4. Remove heat shield by removing (8) nuts which secure it to
the vehicle. Retain (6) nuts for reinstallation after heat
shield trimming.
5. Cut off stud from each frame rail that secured the heat shield.
6. Mark heat shield as shown and trim to allow access to both
frame rails. Reattach trimmed heat shield using (6) nuts
removed in Step 4.
7. Trim vehicle fascia as shown on each side of the vehicle to
allow for hitch side plate reinstallation, approximately 1-3/8"
each side.