Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
39
30
CADILLAC ATS
5/17/2016
11311
60
PAGE 1 of 2
Parts List
DESCRIPTIONPART NUMBERQTYITEM
CARRIAGE BOLT1/2-13 x 1 1/2
41
HEX FLANGE NUTHFN 121342
.250 x 1.00 x 3.00" SQUARE HOLE SPACERCM-SP643
1/2" x 30" FISHWIRE1_2 x 30 FISHWIRE44
DESIGNED FOR USE WITH
BALLMOUNT #45022 (D-230)
EURO MOUNT
OPTION AVAILABLE
#45571 (1 7/8" BALL)
#45572 (2" BALL)
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
1
3
2
4
EXISTING HOLES
(ALL HOLES)
- FISHWIRE HARDWARE
- MAY REQUIRE PANEL/ HEAT
SHIELD TRIMMING
TOOLS REQUIRED
T-15 TORXBIT SOCKET
RATCHET
SOCKET SET
PRY BAR
SPRAY LUBRICANT
CUT-OFF WHEEL
TAPE MEASURE
AVIATION SHEARS
TORQUE WRENCH