Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
CARRIAGE BOLT3/8-16 x 1 1/4 LG.11
HEX FLANGE NUT3/8-1612
.250 x 1.00 x 2.00" SQUARE HOLE SPACERCM-SP723
.250 x 2.13 x 2.13" SQUARE HOLE SPACERCM-SP4814
.250 x 1.00 x 2.00" SQUARE HOLE SPACERCM-SP18
15
CARRIAGE BOLT7/16-14 x 1 1/2
26
HEX BOLT1/2-13 x 2"17
HEX FLANGE NUT7/16-1428
HEX FLANGE NUTHFN 121319
7/16 " FISHWIRE TOOLCM-438-FW110
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
26
60
SAAB 9-3 (SINGLE EXHAUST MODELS)
10/5/2012
11326
120
249326 / 247326
PASSENGER SIDE FRAME RAIL
BUMPER BEAM TAB
TOW HOOK LOOP
9
4
7
8
1
5
8
3
6
6
3
2
1) Remove 2 fascia nuts from under body panel and lower panel from vehicle.
2) Trim under body panel as shown above.
3) Fishwire 7/16" carriage bolt and spacer into the passenger side frame.
4) Use 3/8" and 7/16" fasteners to secure the center of the hitch to the bumper beam tab.
5) Fasten driver side arm to top of tow loop using 1/2" bolt, spacer, and flange nut.
6) Torque all 1/2" fasteners to 110 lb-ft, all 7/16" fasteners to 70 lb-ft, and all 3/8" fasteners to 45 lb-ft.
6.250 in
4.500 in
5.875 in
4.313 in
PLASTIC UNDER BODY PANEL
CUTOUT DIAGRAM
- NO DRILLING REQUIRED
- LOWER AND TRIM FASCIA
DRIVER SIDE
PASSENGER SIDE
REAR OF VEHICLE
10
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501