Owners manual

ManualsBrandsCurt ManualsAutomotiveCURT 113373 Class I 1.25 in. Receiver Hitch Fits 11-13 C30

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE ALL FASTENERS ARE TIGHT AND ALL STRUCTURAL COMPONENTS ARE SOUND

CURT Manufacturing LLC. warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective, Curt Manufacturing LLC. may repair or replace

the product at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement

of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.

For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com

MAKE: STYLE:

MIN.

20/40

WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY

WEIGHT CARRYING:

INSTALLATION TIPS: INSTALLATION TIME:

INSTALLATION REQUIRES:

VEHICLE PHOTO:

HITCH ILLUSTRATION:

REPRESENTATIVE PHOTO

MAKE SURE YOUR HITCH MATCHES

LEVEL OF DIFFICULTY:

MODERATE

EASY MODERATE CHALLENGING

THE INSTALL TIME LISTED IS FOR

PROFESSIONAL/NOVICE INSTALLERS. IF YOU ARE

HESITANT TO UNDERTAKE THIS TASK ON YOUR OWN,

CONTACT AN AUTHORIZED CURT INSTALLER FOR

ADDITIONAL ASSISTANCE.

1. BEFORE YOU BEGIN INSTALLATION, READ ALL

INSTRUCTIONS THOROUGHLY.

2. TO EASE INSTALLATION, 2 PEOPLE MAY BE

REQUIRED.

3. USING PROPER TOOLS WILL GREATLY IMPROVE

THE QUALITY OF THE INSTALL AND REDUCE THE

TIME REQUIRED.

4. NEED HELP OR HAVE SOME QUESTIONS?

CALL TECHNICAL SUPPORT AT 800.798.0813

Safety glasses should be

worn at all times while

installing this product

YEARS:

2011-PRESENT VOLVO MODEL: C30

HATCHBACK

2,000

200

TRAILER WEIGHT:

TONGUE WEIGHT:

11337 INSTALLATION INSTRUCTIONS

LBS.

4/23/2014

WARNING:

WE RECOMMEND THE USE OF 18050 STABILIZING STRAPS FOR ALL NON-TRAILER

(WHEEL-LESS) LOADS. PLEASE SEE THE CURT CATALOG OR VISIT US ONLINE AT

WWW.CURTMFG.COM FOR FURTHER INFORMATION.

SAFETY

GLASSES

TORXBIT

SOCKET

T-25

PART REMOVAL

RATCHET

SOCKET

3/4"

SOCKET

EXTENSION

TAPE

MEASURE

MARKER

AVIATION

SHEARS

TORQUE

WRENCH

TEMPORARILY REMOVE

PLASTIC FASCIA

FISHWIRING REQUIRED

TRIM HEAT SHEILD

AND PLASTIC FASCIA

NO DRILLING REQUIRED

Summary of content (4 pages)

PAGE 1
1337 YEARS: 2011-PRESENT Safety glasses should be worn at all times while installing this product . INSTALLATION INSTRUCTIONS MAKE: VOLVO MODEL: C30 STYLE: HATCHBACK WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY WEIGHT CARRYING: INSTALLATION TIME: TRAILER WEIGHT: TONGUE WEIGHT: 20/40 MIN. THE INSTALL TIME LISTED IS FOR PROFESSIONAL/NOVICE INSTALLERS.
PAGE 2
INSTALLATION WALKTHROUGH: ITEM QTY Parts List PART NUMBER 1. Remove plastic fascia from rear of vehicle to gain access to hitch mounting locations. First, remove (2) screws from plastic mounting brackets using a T-25 Torxbit socket. Then, un-clip plastic from vehicle and gently pull back to remove. DESCRIPTION 1 4 1/2" CONICAL TOOTHED WASHER 2 4 1/2 - 13 x 1 1/2 HEX BOLT 3 2 HFN 1213 HEX FLANGE NUT 4 2 1/2-13 x 1 1/2 CARRIAGE BOLT 5 2 CM-SP6 .250 x 1.00 x 3.
PAGE 3
INSTALLATION WALKTHROUGH: 3. Slide mounting plate assembly up behind the frame mounting lip. Ensure the plate is sitting flush on the back of the mounting surface with the weld nuts pointing toward the front of the vehicle. 5. Mark and trim both heat shield and plastic rear fascia as shown. Bend heat sheild up into its concealed position. Reattach plastic fascia by clipping back onto vehicle and securing both screws on sides of vehicle. 1.50" 6.00" 4.
PAGE 4
11337 VOLVO C30 4/23/2014 GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: 2,000 LBS. TRAILER WEIGHT & 200 LBS. TONGUE WEIGHT. ***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.*** WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.