Installation Guide

I NSTALLATI ON W ALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
9. Raise hitch and bumper beam into position and secure to
the vehicle with the M8 bolts removed in STEP 7. Torque
all M8 hardware to 23 ft-lbs.
10. Reinstall bumper cover by reassembling components
removed in STEPS 1-6 in reverse order.
11. Install is now complete.
4.25 in
2.38 in
Remove
8. With a rotary tool remove alignment stud (each side as
shown) and trim the center of the underbody panel (as
shown).
Trim