Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. If the rear-most driver side hole is not present, raise the
hitch into position and mark the hole to be drilled. Lower
the hitch and drill marked hole. Note
: Before drilling hole
make sure all existing holes are aligned. Enlarge the driver
side access hole to allow 7/16" hardware to pass through.
4. Fishwire the 7/16" carriage bolt and SP2 spacer through
the enlarged access hole and out the rear-most hole.
5. Reverse fishwire the 7/16" carriage bolt and SP2 spacer
into the enlarged access hole.
6. Raise the hitch into position and secure the driver side using
the provided 7/16" flange nuts. Secure the passenger side
with either the existing (2) M12 bolts into the existing weldnuts
in the side of the frame or the existing (3) M10 bolts through
the frame rail and secure using the provided M10 flange nuts.