Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Raise hitch into position starting with the drivers side
carefully pulling out the bumper cover to allow the hitch
to slide into position. Secure the hitch in place using the
supplied (4) M8 hex flange bolts as shown below.
4. Place (2) 1/2" carriage bolts into the square holes in the
chain loop plate. Reattach exhaust and secure bumper
cover using the (2) outer fasteners removed in Step 1.
Note: Center attachment is no longer accessible.
5. Remove the contents of the trunk including the spare tire.
Remove both plugs from the spare tire well and return
to vehicle owner.
6. Use silicone caulk (or equivalent) to seal the tire well plug
hole from exhaust fumes and water by putting a bead around
each hole inside the spare tire well. Place a 11410-SP
spacer onto each hole and put a bead of caulk around each
square hole. Install a 1/2" carriage bolt into each hole.