Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
7/16 " FISHWIRE TOOLCM-438-FW11
FW, 12, ZPFW1232
HEX BOLT1/2-13 x 2"13
HEX FLANGE NUT
HFN 121344
.250 x 1.50 x 2.00" ROUND HOLE SPACERCM-SP16
15
.250 x .88 x 2.25" SQUARE HOLE SPACERCM-SP216
CARRIAGE BOLT7/16-14 x 1 1/417
LARGE HEX FLANGE NUT7/16-1418
HEX BOLT1/2-13 x 139
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
19
35
SUZUKI RENO
11/30/2012
11442
70
249442 / 247442
1. Remove (2) 10mm hex bolts from passenger side to remove wire harness bracket and
expose frame access hole required for hitch installation.
2. Enlarge access hole as needed to allow bolt and square hole spacer to pass through.
Fishwire carriage bolt and square hole spacer into hole as shown.
3. Lift hitch into position and fasten to existing holes with (2) hex bolts on driver side, and (1)
hex bolt on passenger side.
4. Secure to tow loop with 2" hex bolt and spacer as shown.
5. Torque all 7/16" fasteners to 70 lb-ft and all 1/2" fasteners to 110 lb-ft.
6. Reinstall passenger side wire harness bracket that was removed in step 1.
6
7
2
1
5
2
4
3
8
- DRILLING REQUIRED
-
LOWER BRACKET
- FISHWIRING REQUIRED
VEHICLE TOW LOOP
UNDERBODY FLANGE
REMOVE WIRE HARNESS BRACKET
BEFORE HITCH INSTALLATION
PASSENGER SIDE
FRAME RAIL
9
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501