Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
3.
Raise hitch into position aligning it with the hole in the frame rail
seen under the trimmed section of heat shield. Use the hitch to
mark the rearward most mounting holes. Remove hitch and using a
½” drill bit, drill the marked locations and enlarge to reverse fishwire
hardware in both frame rails.
*** shown with heat shield removed for clarity ***
4. Reverse f
ishwire the 1 1/2" long carriage bolts and spacers through
the holes drilled in step 3. Then reverse Fishwire the remaining
1" short carriage bolts and spacers into the forward most mounting
slots. (See Fishwire technique)
*** shown with heat shield removed for clarity ***
5. Raise the hitch into position with care not to push the fasteners
back into the frame rail and loosely secure with the supplied hex
flange nuts.
6. Torque all 7/16" hardware to 59 ft-lbs. Reinstall exhaust in reverse of
step 1.