Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
WARNING: ALL NON-TRAILER (WHEEL-LESS) LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
WARNING:
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY **
WARNING: *** DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY ***
FOR MORE INFORMATION LOG ONTO WWW.CURTMFG.COM
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser.
If the product is found to be defective, CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid,
with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. CURT Manufacturing LLC.'s liability is limited to
repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.Regulation V-5 and SAE J684.
2,000 200
27
60
HONDA ACCORD (SEDAN)
07/02/2020
11525
120
Scan
for more
information
PAGE 1 of 2
Parts List
DESCRIPTIONPART NUMBERQTYITEM
BOLT,CAR,7/16-14 UNC,1-1/2,GRD8,YZ
10-1028221
BOLT,CAR,7/16-14 UNC,1,GRD8,YZ10-1031122
NUT,SER-FLANGE,7/16-14 UNC,GRD8,YZ20-0010343
.250 x .88 x 2.25" SQUARE HOLE SPACERCM-SP224
.250 x 1.00 x 3.00" SQUARE HOLE SPACERCM-SP62
5
7/16" FISHWIRE7_16 FISHWIRE46
1
3
6
DRIVER SIDE FRAME RAIL
PASSENGER SIDE
FRAME RAIL
EXISTING SLOT
(BOTH FRAMES)
- DRILLING REQUIRED
- LOWER EXHAUST
- TRIM HEAT SHIELDS
- TEMPORARILY REMOVE
PASSENGER SIDE MUFFLER
EXISTING ACCESS SLOT
(BOTH FRAMES)
2
EURO MOUNT
OPTION AVAILABLE
# 45561 (1 7/8" BALL)
# 45562 (2" BALL)
DESIGNED FOR USE WITH
BALL MOUNT # 45520
2
1
5
4