Owners manual

ManualsBrandsCurt ManualsAutomotiveCURT 11546 Class I 1.25 in. Receiver Hitch Fits 86-89 Stanza

Parts List

DESCRIPTION

PART NUMBER

QTY

ITEM

HEX BOLT1/2-13 x 1 3/421

HEX FLANGE NUTHFN 121322

HEX FLANGE NUTHFN381643

.188 x 1.50 x 3.00" ROUND HOLE SPACERCM-SP342

BOLT PLATE WELDMENT ASSEMBLYCM-11546-BPWA

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***

WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.

** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813

HITCH WEIGHT:

LBS.

INSTALL TIME

PROFESSIONAL: MINUTES

NOVICE (DIY): MINUTES

INSTALL NOTES:

INSTALLATION STEPS

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS

ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

1,500 150

86-89 NISSAN STANZA 4WD WAGON

12/14/2012

11546

217248

1. Position the hitch on the vehicle with side plates against the outside of the vehicle's (2) tie down brackets.

Loosely install fasteners as shown.

2. Trim the bumper fascia to allow the hitch bumper bracket to sit on the bottom surface of the steel inner

bumper. Using hitch as a template, mark and drill bumper (4) places for 3/8" bolts.

3. Lower the hitch and place bolt plates (CM-11546-BPWA) inside the steel bumper so that the bolts extend

out of the bottom. Mount the hitch on these bolts using fasteners as shown.

4. Torque all 3/8" fasteners to 45 lb-ft, and all 1/2" fasteners to 110 lb-ft.

STEEL

BUMPER BEAM

DRIVER SIDE

FRAME RAIL

PASSENGER SIDE

FRAME RAIL

- DRILLING REQUIRED

- FASCIA TRIMMIMG REQUIRED

TIE DOWN BRACKETS

DRILL

HOLES