Owners manual
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
1,000 100
5
20
90-92 DAIHATSU ROCKY
12/14/2012
11562
40
217268
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLT1/2-13 x 1 3/4
4
1
FW, 12, ZPFW1282
LOCK WASHER1/2"43
HEX NUT
1/2-13
44
4
3
2
2
1
-NO DRILLING REQUIRED
-
REMOVE TOW LOOP
1. This hitch mounts at the center of vehicle's rear cross member in place of vehicle's tow loop. Remove
tow loop and return to vehicle's owner for reinstallation should the hitch ever be removed.
2. Mount the hitch at the tow loop holes as shown in diagram. The fasteners provided with hitch should be
installed as shown.
3. Torque all 1/2" fasteners to 110 lb-ft.
CROSS MEMBER