Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS


Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
1,000 100
11
30
73-79 VOLKSWAGEN TRUCK / BUS
12/7/2012
11655
60
217399
Parts List
DESCRIPTIONPART NUMBERQTYITEM
LOCK WASHER3/8"21
HEX NUT3/8 - 1622
U-BOLT3_8-16 x 1.625 SQ. U-BOLT13
NYLOCK HEX NUT3/8-1624
HEX BOLT3/8 - 16 x 1 1/425
WASHER3/8"26
1. Locate the center of the rear bumper. Position U-bolt over vehicle's crossmember on center as shown.
Place hitch onto U-bolt and position under rear bumper. Fasten hitch to U-bolt with lock nuts.
2. Drill rear bumper through hitch for 3/8" fasteners. Fasten in place using flat washers and bolts inside
the bumper, and lock washers and nuts on the outside.
3. Torque all 3/8" fasteners to 45 lb-ft.
2
1
4
BUMPER BEAM
CROSSMEMBER
- DRILLING REQUIRED
DRILL HOLES
5
6
3