Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
1. Lower exhaust by removing two rubber exhaust isolators
for single exhaust vehicles and three isolators for dual
exhaust vehicles. See RUBBER ISOLATOR REMOVAL
DIAGRAM below.
2. Remove heat shield(s) by removing four fasteners per
shield. Save fasteners for reinstallation.
3. Fishwire 7/16"-14 x 1 1/4" carriage bolts with CM-SP2
spacers into poistion through access holes in both frame
rails, as shown on page 1. See FISHWIRE TECHNIQUE
DIAGRAM below. NOTE: Leave fishwires attached to
prevent loss of hardware inside of frame rail.
4. Insert 3/8" U-bolt through tow hook, as shown.