Owners manual

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
- NO DRILLING REQUIRED
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
20
30
1991-1992 VOLKSWAGEN GOLF
12/10/2012
11714
60
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM10 - 1.5 x 80 HEX41
HELICAL LOCK WASHER7/16 LOCK WASHER42
WASHER3/8"43
1. Under the rear of the car at the left and right sides; locate the frame rails (box member) with two recessed
10mm bumper attach bolts in each rail. Remove both bumper bolts in each frame rail. The hitch will mount
at these points.
2. Position the hitch on the car as shown. Work the hitch above the exhaust system on the dirver's side.
Disconnect the rear exhaust hangers if necessary. Using fasteners provided with the hitch, mount the hitch
at the points securing the hitch and bumper to the car chassis. Be certain to use washers as shown.
3. Torque all 10mm hardware to 45 ft-lbs.
3
2
1
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
RECESSED 10MM WELD NUTS
(BOTH SIDES)
DESIGNED FOR USE WITH
BALL MOUNT # D-55001 / 45501