Owners manual

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
26
45
90-91 HONDA PRELUDE
12/17/2012
11725
90
247252
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
CONICAL TOOTHED WASHER7/16"41
HEX BOLTM10 - 1.25 x 40 HEX42
HELICAL LOCK WASHER7/16 LOCK WASHER23
HEX NUT7/16-1424
CARRIAGE BOLT7/16-14 x 1 1/22
5
.250 x .88 x 2.25" SQUARE HOLE SPACERCM-SP226
7/16 " FISHWIRE TOOLCM-438-FW17
5
1
2
3
4
DRIVER SIDE
FRAME RAIL
INSTALL FASTENERS THROUGH
EXISTING ACCESS HOLE
1. Locate the driver and passenger side frame rails under the rear of the vehicle. Remove the tie down brackets
from each frame rail ((2) 10mm bolts each). Return all parts to the vehicle owner for reinstallation should the
hitch ever be removed.
2. Lift the hitch into position and note location of the fascia interference at the hitch frame plates. Trim fascia until
hitch will fit as shown. Lower the hitch.
3. Using the existing access hole in each frame rail, fishwire 7/16" carriage bolts and CM-SP2 spacers into rear
hole in each frame rails, as shown.
5. Raise hitch into position and bolt the hitch to the vehicle using fasteners as shown.
6. Torque all 10mm fasteners to 48 lb-ft, and all 7/16" fasteners to 70 lb-ft.
- NO DRILLING REQUIRED
- REMOVE TIE DOWN BRACKETS
- TRIM FASCIA
- FISHWIRE HARDWARE
7
6
EXISTING WELDNUTS
(BOTH SIDES)
EXISTING HOLE
(BOTH SIDES)
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501