Owners manual

Parts List
ITEM
QTY
PART NUMBER
DESCRIPTION
1 2 1/2-13 x 1 3/4
HEX BOLT
2 4 1/2" CONICAL TOOTHED WASHER
3 2 M12 - 1.25 x 40 HEX HEX BOLT
4 2
1/2-13
HANDLE NUT
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3,500 300
29
20
2007 - 2009 ACURA RDX
11/19/2012
12004
40
4
2
1
3
DRIVER SIDE
FRAME RAIL
EXISTING WELDNUT
(BOTH SIDES)
PASSENGER SIDE
FRAME RAIL
EXISTING HOLES
(BOTH SIDES)
1) Raise hitch into position and align holes on hitch with holes in frame rail.
2) Install rearmost bolts hand-tight to secure hitch to frame.
3) Insert bent handle nuts as shown and install remaining hardware.
4) Torque M12 hardware to 86 lb-ft. and all 1/2" hardware to 110 lb-ft.
TOOLS REQUIRED
RATCHET
19mm SOCKET
TORQUE WRENCH
- NO DRILLING REQUIRED
- NO FISHWIRING REQUIRED
1 3/26/2007 KWS
2 "2007 - 2009 ACURA RDX" WAS "ACURA RDX" 2382 7/6/2010 BHR
3
CHG TO GRADE 8 TORQUE SPECS
11/19/2012 AJP
4 REPLACED 45520 WITH 45522 4662 5/29/2018 AGC
REVISION HISTORY
REV DESCRIPTION INC.# DATE APPROVED
DESIGNED FOR USE WITH
BALL MOUNT # D-221 / 45522