Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLT
M12-1.75 x 40mm61
FW, 12, ZPFW12122
LOCK WASHER1/2"63
HEX NUTM12 - 1.7564
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
- NO DRILLING REQUIRED
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3500 350
38
45
12011
10/12/2012
83-04 CHEVROLET / GMC S-10, S-15 & SONOMA PICKUPS (INCLUDING SPORT SIDE)
96-00 ISUZU HOMBRE
1994-1997
BUMPER BRACKET
CONFIGURATION
1998-PRESENT
BUMPER BRACKET
CONFIGURATION
PLASTIC STEP
TREAD
SPORTSIDE BED MODELS
Note: Some spare tires may need to be lowered and repositioned for hitch installation
1) Remove bumper bracket bolts and return to vehicle owner.
2) Position hitch on frame and install fasteners as shown above.
STEP BUMPER MODELS
1) Remove bumper, leaving brackets attached to frame. Disconnect bumper wiring and remove bumper.
Note: Pre-1994 models, bumper is attached to each bracket by two horizontal bolts.
1994-1997 models, bumper is attached to each bracket by two vertical bolts.
1998-present, remove plastic tread from top of bumper. The bumper is attached with four vertical bolts.
2) Remove bumper brackets from frame. Remove bumper wiring guides from bumper brackets.
3) If installing hitch on an early model vehicle using a cradle storage system for the spare tire, mark the spare tire
carrier 1/8" inboard of outer frame edge. Lower spare tire and cut off carrier along previously marked line.
4) Position receiver on frame and loosely install bumper brackets using (3) M12 bolts and fasteners per side.
Receiver brackets are positioned between bumper brackets and frame.
5) Pre-1994 models, reinstall bumper on bumper brackets with original bolts, using (3) 1/2" washers at each
bolt location as spacers between brackets and bumper. ( see above)
6) Raise spare tire back into position and secure. Reconnect bumper wiring.
7) Torque all fasteners to 110 lb.-ft
4
3
2
1
DESIGNED FOR USE WITH
BALL MOUNT # D-19 / 45519