Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com.
4. Raise the hitch into position and slide the bolts in the side
of the frame rails through the hole in the hitch. Loosely
secure hitch with 1/2" hex flange nuts. Note: The carriage
bolts should sit flat on the spacers. Note: For ease of
installation raise the driver side into position first, then
raise the passenger side.
5. Align the bottom tabs of the hitch with the weldnuts in the
frame rails and secure with M10-1.25 x 25mm bolts and
3/8" conical toothed washers.
3. Note: On 2020 or newer model years, fascia trimming
may be required. Using a dremel tool or aviation shears,
trim the fascia as shown in the trim diagram on both driver
and passenger side of vehicle. Dimensions are
approximate, trim as required.
6. Reinstall charcoal canister removed in step 2.
7. Torque all 10mm hardware to 48 ft-lbs.
Torque all 1/2" hardware to 110 ft-lbs.
Install Complete.
.25 1.50