Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
FISHWIRE TOOL1/2"
11
HEX TAP BOLT5/16-18 x 1 1/4 LG.42
LOCK WASHER5/16"43
WASHER5/16"84
HEX NUT5/16-184
5
CARRIAGE BOLT1/2 - 13 x 2 1/426
.250 x 1.00 x 2.00" SQUARE HOLE SPACERCM-SP1227
HEX FLANGE NUTHFN 121328
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3500 350
43
30
97-99 CADILLAC DEVILLE
10/8/2012
12055
60
36267
1) Lower exhaust system. Support exhaust system to prevent damage from excess travel.
2) Remove the bottom outboard & inboard E/A bolt, each side, and return to owner.
3) Fishwire carriage bolts and carriage blocks through access hole in frame rail as shown.
4) Raise hitch into position between E/A unit and exhaust hanger. Install fasteners as shown.
(Note: Be careful not to push bolts back into frame while positioning hitch.)
5) Re-attach the exhaust system. Check and tighten all fasteners. Torque 5/16" bolts to 24
lb.-ft. Torque 1/2" hardware to 110 lb.-ft.
ACCESS HOLE
FRAME RAIL
FRAME RAIL
EXHAUST HANGER GOES
BETWEEN HITCH & FASTENERS
2
1
4
3
5
6
7
8
-NO DRILLING REQUIRED
DESIGNED FOR USE WITH
BALLMOUNT # D221 / 45522