Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Enlarge access holes to allow 7/16"-14 carriage bolts and
SP7 spacers to pass through. Fishwire 7/16"-14 carriage
bolts and SP7 spacers through the enlarged access holes
and out the holes drilled in Step (2).
4. Raise hitch into position and loosely secure the rear most
holes with 7/16"-14 flange nuts. Sandwich the hitch side
plates between the frame rails and the driver side exhaust
bracket, secure with M8-1.25 hex bolts and 3/8" conical
toothed washers.
5. Torque all M8 hardware to 23 ft-lbs.
Torque all 7/16" hardware to 70 ft-lbs.
Install Complete