Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3500 350
30
30
MAZDA CX-9
3/23/2015
12112
60
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM12-1.25 x 30mm61
CONICAL TOOTHED WASHER1/2"62
HEX HEAD BOLTM8 - 1.25 x 30 HEX BOLT23
CONICAL TOOTHED WASHER3/8"24
PASSENGER SIDE
FRAME RAIL
3
4
2
1
EXISTING
WELDNUTS(ALL)
DRIVER SIDE
FRAME RAIL
TOOLS REQUIRED
19mm SOCKET
13mm SOCKET
TORQUE WRENCH
RATCHET
1) Raise hitch into position.
2) Attach, finger tight, with (3) M12 hex bolts and 1/2" conical toothed washers and (1) M8 hex bolt with
a 3/8" conical washer per side.
3) Torque all M12 hardware to 86 ft-lb and all M8 hardware to 23 ft-lb.
-NO DRILLING REQUIRED
DESIGNED FOR USE WITH
BALLMOUNT #D-21/45521
DESIGNED FOR USE WITH
EURO BALLMOUNT # 45571
(1 7/8" BALL) OR #45572 (2" BALL)