Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HHCS,M12x1.25,35,CL10.9,YZ10-10275
5
1
WASHER,S-CON,1/2,YZ30-0014952
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original
purchaser. If the product is found to be defective, Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is
returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. Curt Manufacturing
LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential
loss or damage.
3500 350
26
45
NISSAN ROGUE
07/15/2020
12122
90
EXCLUDING KROM EDITION
Scan
for more
information
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
EXISTING WELDNUTS
(BOTH FRAME RAILS)
- REMOVE TIE DOWN
- LOWER EXHAUST
- NO DRILLING
- REMOVE PANELS IF PRESENT
1) Remove lower underbody panels, if present, using a small screwdriver and phillips head screwdriver and
return to customer.
2) Remove tow hook / bracket from the passenger side frame rail (4-5 bolts) and return to customer.
3) Lower exhaust for ease of installation.
4) Raise hitch into position and secure with hex bolts and conical washers, as shown in the diagram above.
5) Torque all 12mm fasteners to 86 LB-FT.
6) Reinstall exhaust, if removed in step 3.
2
1
EURO MOUNT OPTIONS:
#45591 (1 7/8" BALL)
#45592 (2" BALL)
TOOLS REQUIRED
3/8" DRIVE RATCHET
3/8" DRIVE 8" EXTENTION
3/8" DRIVE TORQUE WRENCH
8mm - 3/8" DRIVE SOCKET
18mm - 3/8" DRIVE SOCKET
19mm - 3/8" DRIVE SOCKET
FLAT & PHILLIPS SCREWDRIVER
WIRE PIPE BRUSH
SAFETY GLASSES
DESIGNED FOR USE WITH
BALL MOUNT # 45522