Owners manual

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
HEX BOLT
M12-1.75 x 40mm81
CONICAL TOOTHED WASHER1/2"82
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3,500 300
22
10
9/27/2017
12209
20
36195 / 367212
EXISTING WELDNUT
DRIVERS SIDE
FRAME RAIL
-NO DRILLING REQUIRED
-REMOVE TIE DOWN BRACKET
-TRIM FASCIA PANEL
1. Remove the tie down bracket from bottom of left frame rail. Remove plastic plug from right frame rail.
Remove the plastic trim panel running across under the car on all models except for 780.
2. Lift the hitch into position on vehicle frame rails and mount using fasteners as shown.
3. Plastic trim panel must be notched at top edge for hitch receiver clearance. Hold panel up to locate
notch and cut only enough to clear hitch. Reinstall the plastic trim panel.
780 MODELS ONLY:
2. Lift hitch into position on vehicle lining up with weld nuts until hitch meets plastic trim panel. Mark
panel for receiver clearance. Lower hitch.
3. Trim panel just enough to clear receiver tube with hitch in position on frame rails. Install hitch as shown.
4. Torque all hardware to 79 lb.-ft.
1 GENERIC INSTRUCTION SHEET 7/9/2007 DWS
2 CAPPED YEARS 6/11/2009 CFM
3 UPDATED TEMPLATE
9/1/2009 CFM
4 UPDATED TO CURRENT STANDARDS 12/14/2009 SMN
5
CORRECTED BALL MOUNT CALL OUT 12/18/2009 CJL
6
CHG TO GRADE 8 TORQUE SPECS
10/15/2012
AJP
7
UPDATED WEIGHT RATING FROM
3500/350
9/27/2017 AGC
REVISION HISTORY
REV DESCRIPTION DATE APPROVED
84-93 VOLVO 740 SERIES, 83-96 760 SERIES, 88-90 780 (COUPE),
91-95 940 SERIES, 91-94 960 SERIES
1
2
PASSENGER SIDE
FRAME RAIL
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501