Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HANDLE NUT1/2-1321
HEX BOLT1/2-13 x 1 3/422
LOCK WASHER1/2"33
CARRIAGE BOLT1/2-13 x 1 3/414
HEX NUT1/2-1315
.188 x 1.00 x 3.00" SQUARE HOLE SPACERCM-SP4016
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS


Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3500 300
25
20
7/18/2012
12211
40
36262 / 367233
TOW HOOK
-DRILLING REQUIRED
ON SOME MODELS
1) Temporarily lower exhaust at rear of car by unhooking hangers. Locate chassis end brackets under rear of
car where bumper attaches. Temporarily lift hitch into position as shown. Some sedans will require drilling
through these bottom inboard holes into bumper bracket and bumper for end clearance of bolts.
2) Handle nuts must fit between rear side of chassis end brackets and bumper. On certain models it may be
necessary to loosen rear bumper from chassis temporarily to place handle nuts.
3) Raise hitch into position and install fasteners as shown.
4) Torque all hardware to 110 lb.-ft.
2
1
4
93-97 VOLVO 850, 98-00 S70, 98-00 V70, 98-04 C70, 98 V70R
3
5
6
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501