Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM12-1.75 x 40mm61
FW, 12, ZPFW1262
LOCK WASHER1/2"
63
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3500 300
27
25
11/19/2012
12213
50
37102
1. This hitch mounts to the existing weld nuts in the frame rails. Remove the tie down bracket from driver side
frame rail and return it to the owner of the vehicle for reinstallation should the hitch ever be removed.
Temporarily unbolt both exhaust hangers to ease installation.
2. Lift the hitch into position over the passenger side exhaust and locate the frame rails. Install fasteners in
weld nuts as shown in diagram.
3. Torque all 12mm fasteners to 79 lb-ft.
-NO DRILLING REQUIRED
-REMOVE TIE DOWN
-LOWER EXHAUST
2
3
1
EXISTING WELD NUTS
IN FRAME RAILS
(BOTH SIDES)
DRIVER SIDE FRAME RAIL
PASSENGER SIDE FRAME RAIL
95-97 VOLVO 960, 1998 VOLVO S90 & V90
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501