Owners manual

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3,500
300
28
40
12217 93-03 VOLKSWAGEN EUROVAN
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
HANDLE NUT1/2-1311
HEX BOLT7/16-14 x 1 1/462
HEX FLANGE NUT7/16-1463
HEX BOLTM12-1.5 x 35mm44
CONICAL TOOTHED WASHER1/2"6
5
HEX FLANGE NUTHFN 121316
HEX BOLT1/2-13 x 1 1/4
27
1) Remove the two rear most frame bolts that attach the bumper brackets to the frame rails.
Mount side plates to inner surface of frame rails aligning rear most holes with existing
weldnuts in bumper bracket. Loosely install fasteners as shown.
(Note: It may be necessary to remove plastic clips holding wire bundle inside passenger side frame.)
2) Mount receiver assembly between frame plates and install fasteners as shown.
3) Torque 1/2" fasteners to 110 lb.-ft., M12 fasteners to 83 lb.-ft., and 7/16" fasteners to 70 lb.-ft.
DRIVERS SIDE
FRAME RAIL
BUMPER BRACKET
EXISTING WELD NUTS
SIDE PLATE
5
4
2
3
1
6
NO DRILLING REQUIRED
7
10/15/2012
PASSENGER SIDE
FRAME RAIL
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501