Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,500 250
23
15
12228 TOYOTA MATRIX AND PONTIAC VIBE (Will not fit GT)
07/02/2020
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HHCS,M12x1.25,30,CL10.9,YZ10-1041941
WASHER,S-CON,1/2,YZ30-0014942
DRIVER SIDE
FRAME RAIL
EXISTING WELDNUTS IN THE FRAME RAIL
(BOTH FRAME RAILS)
Note: On Toyota Matrix XRS and XR Sport models there is lower valance that must be trimmed for hitch
installation.
1) Raise hitch into position over the exhaust. Align the slots in the hitch with the weldnuts in the frame
rails closest to the rear end of the vehicle.
2) Install hex bolts and conical tooth washers into weldnuts.
3) Torque bolts to 86 lb-ft.
- NO DRILLING REQUIRED
PASSENGER SIDE
FRAME RAIL
2
1
DESIGNED FOR USE WITH
BALL MOUNT # D-55001
TOOLS REQUIRED
RATCHET
10" EXTENSION
19mm SOCKET
TORQUE WRENCH
- HEAT SHIELD MODIFICATION
MAY BE REQUIRED

Summary of content (1 pages)