Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLT
M12 - 1.25 x 40 HEX61
LOCK WASHER1/2"62
WASHER7/16 WASHER63
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2500
250
25
30
12231 / 257251 01-06 LEXUS LS 430 SEDAN
10/8/2012
1) Under the rear of the car, locate the exhaust mufflers at the left and right side of the car. The mufflers are
supported at the rear of the vehicle by flexible supports and brackets bolted into the chassis with three
12mm screws per bracket.
2) Temporarily remove these brackets from the chassis on both sides. Position the hitch on the vehicle at
these same mounting points. Re-mount the brackets at the bottom of the hitch brackets on both sides.
Mount using fasteners provided with the hitch.
3) Torque all 12mm fasteners to 86 lb-ft.
NO DRILLING REQUIRED
3
2
1
EXISTING WELD NUTS
(BOTH SIDES)
DRIVER SIDE OF
SPARE TIRE WELL
PASSENGER SIDE OF
SPARE TIRE WELL
DESIGNED FOR USE WITH
BALL MOUNT # D-55010