Owners manual

ManualsBrandsCurt ManualsAutomotiveCURT 122893 Class II 1.25 in. Receiver Hitch Fits Grand Caravan Town & Country

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***

HITCH WEIGHT: LBS.

INSTALL TIME: MINUTES

INSTALL NOTES:

INSTALLATION STEPS

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS

ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

3,500

350

12289 04-07 CHRYSLER / DODGE CARAVAN (STOW 'N GO)

INCLUDING GRAND CARAVAN

1. Remove the three 10mm bolts attaching the rear spring shackle to the vehicle's frame. Also remove the

single 12mm bolt from the vehicle just forward of the spring shackle. Save all of these bolts for later hitch

installation.

2. Position the hitch's left mounting tab on the driver side over the leaf spring near the rear axel. Then pull

this side of the hitch towards the rear of the vehicle and into position. Repeat this procedure on the

passenger side of the vehicle.

3. Raise the hitch into position so it contacts the vehicles frame rail. Align the 3 holes in the hitch with the

holes in the vehicle's frame where fasteners were removed. Bolt the hitch in place using previously

removed fasteners.

4. Torque all 10mm fasteners to 48 lb-ft, and all 12mm fasteners to 86 lb-ft.

NO DRILLING REQUIRED

NO FASCIA TRIMMING REQUIRED

EXISTING 10MM FASTENERS

(BOTH SIDES)

EXISTING 12MM FASTENER

(BOTH SIDES)

EXISTING WELD NUTS

(ALL)

7/18/2012

DESIGNED FOR USE WITH

BALL MOUNT # D-20 / 45520