Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
FISHWIRE TOOL1/2"
11
FISHWIRE TOOLCM-.375-FW
12
CARRIAGE BOLT1/2-13 x 1 3/433
.250 x 1.00 x 2.50" SQUARE HOLE SPACERCM-SP1034
.250 x 1.00 x 2.00" SQUARE HOLE SPACERCM-SP1815
CARRIAGE BOLT3/8 - 16 x 1 3/416
HEX FLANGE NUTHFN 12133
7
HEX FLANGE NUTHFN381618
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3,500
300
35
40
12292 FORD TAURUS X SEL 3.5L SINGLE EXHAUST
10/12/2012
TRUNK PAN
DRIVER SIDE FRAME RAIL
PASSENGER SIDE FRAME RAIL
MUFFLER
RUBBER MUFFLER HANGER BRACKET
(INSERT RUBBER MUFFLER HANGER
ONTO THE EXHAUST HANGER TAB)
1) Lower muffler by removing 2 screws in the exhaust hanger bracket. (discard exhaust bracket)
2) Fishwire bolts and square hole spacers into position through access holes on the frame rails.
(3/8" fasteners and spacer goes into the forward most hole on the passenger side)
3) Raise hitch into position and install remaining fasteners.
4) Torque all 3/8" fasteners to 45 ft-lb and all 1/2" fasteners to 110 ft-lb.
5) Re-install muffler onto hitch exhaust hanger tab.
- NO DRILLING REQUIRED
- LOWER MUFFLER AND RUBBER
HANGER
8
7
5
6
2
1
4
3
REVERSE PULL BOLT AND SPACER
WITH FISHWIRE USING LARGE ACCESS HOLE
USE THESE ACCESS HOLES
REVERSE PULL
FISHWIRING DIAGRAM
DESIGNED FOR USE WITH
BALLMOUNT #D-55001