Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
.250 x 1.50 x 2.00" SQUARE HOLE SPACERCM-SP1
61
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ
20-0006242
BOLT,CAR,1/2-13 UNC,1-3/4,GRD8,YZ
10-1027243
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 877-287-8634
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
4,000 400
6,000
600
FORD RANGER & MAZDA B2300, B3000, B4000
6/22/2020
13019
90
31
45
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
75082/RRH13019
3
Place between frame and
hitch if vehicle is equipped
with a step bumper
BUMPER BRACKET
2
1
1997 and Prior Models
Note: 19mm open end style wrench
must be purchased to allow removal of
spare tire after hitch installation
- DRILLING REQUIRED
NOTE: Relocation of spare tire bracket is NOT required.
1) For vehicles with step bumper, remove rearmost bumper bracket bolts and J-Nuts (both sides).
2) Position hitch on vehicle, sandwiching the bumper brackets (if present) between the hitch and the vehicle
frame, install rearmost fasteners.
3) Using hitch as a template, drill two (2) 1/2" holes into frame at forward end of hitch.
NOTE: On some models, the holes may already exist.
4) Install remaining fasteners as shown. For vehicles with step bumper, place a square hole spacer between
frame and side brackets at forward attachment.
5) Torque 1/2 fasteners to 110 lb-ft.
1 GENERIC INSTRUCTION SHEET 7/3/2007 CJL
2 REMOVED HITCH INFO 11/116/2007 DWS
3
UPDATED TO STANDARD INS 9/08/2009 CMB
4
CHG TO GRADE 8 TORQUE SPECS
7/11/2012
AJP
5
REVISED NOVICE AND PROFESSIONAL INSTALL TIMES 11/15/2012
RJK
6
UPDATED HARDWARE NUMBERS/DESCRIPTIONS 6/22/2020 CJW
REVISION HISTORY
REV DESCRIPTION DATE APPROVED