Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX FLANGE NUT9_16-12 FLANGE NUT21
HEX BOLT
M12 - 1.25 x 40 HEX42
CONICAL TOOTHED WASHER1/2"43
FW, 12, ZPFW1224
HEX FLANGE NUTHFN 12132
5
FLAT WASHER9_16 WASHER26
HEX BOLT9/16-12 x 1 1/22
7
HEX BOLT1/2 - 13 x 1 1/2
28
1.566 SQ. x .250" REINFORCEMENT BRACKETCM-13045-B29
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
5,000
500
45
30
8,000
800
13045 93-98 TOYOTA T100 (4WD ONLY)
10/15/2012
1) Remove the hardware from both sides that secure the bumper mounting brackets from the rear mount side
of the vehicle.
2) Install frame reinforcement bracket inside the frame rail so that the longer leg sits flat against the bottom of
the frame and the holes line up with the slots in the frame rails.
NOTE: If the hole in the bumper mounting bracket does not line up with the hole in the reinforcement bracket, it
may need to be drilled out with a 1/2" bit.
3) Remove the front two bolts on both sides.
4) Raise the hitch into position and install M12 x 1.25 x 40mm and conical tooth washer through the hitch and
into weldnut in frame as shown.
5) Install remaining fasteners as shown. Torque all M12 fasteners to 86 lb.-ft., all 1/2" fasteners to 110 lb.-ft., and
all 9/16" fasteners to 150 lb.-ft.
3
7
5
2
4
8
- DRILLING MAY BE REQUIRED
9
DRIVERS SIDE
FRAME RAIL
EXISTING WELDNUT
EXISTING HOLE
6
1
PASSENGER SIDE
FRAME RAIL