Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME:
MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
6,000
600
30
35
8,000
800
13055 FORD ECONOLINE VAN ( E-150, E-250, E-350 )
5/7/2020
Parts List
DESCRIPTIONPART NUMBERQTYITEM
WASHER,FLAT,1/2,YZ
30-0013321
BOLT,CAR,1/2-13 UNC,2,GRD8,YZ
10-1028862
.250 x 1.50 x 2.00" SQUARE HOLE SPACERCM-SP1
63
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ20-0006264
1) If present, lower carbon canister from driver side frame rail.
2) Install forward and rearward carriage bolts and spacer in frame rails as shown.
(NOTE: On E-150 models using the hitch as a template drill holes as shown above and enlarge holes as
needed.)
3) Raise hitch into position and hand tighten forward and rearward fasteners to both rails as shown.
4) Install center carriage bolt and spacer in frame placing flat washers between rails and hitch as shown.
(Do not overlap spacers)
5) Torque all 1/2" fasteners to 110 lb-ft.
6) Reattach carbon canister if present - carbon canister must not contact bolt head, if it does, loosen
canister fasteners and reposition to ensure clearance with bolt heads.
- LOWER CARBON CANISTER
(IF PRESENT)
- NO DRILL ON E-250/350
- DRILL ON E-150
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
CARBON CANISTER
(IF PRESENT)
CANISTER MUST NOT
CONTACT BOLT HEAD
EXISTING HOLES IN FRAME RAIL
(ALL EXISTING - NO DRILLING)
2
3
4
1
TOOLS REQUIRED
RATCHET
3/4" SOCKET
7/8" SOCKET
TORQUE WRENCH
DRILL
17/32" DRILL BIT
ENLARGE HOLE
(E-150 IF NEEDED)
DRILL HOLE
(E-150 ONLY)
DRILL HOLE
(E-150 ONLY)
DRILL HOLE
(E-150 ONLY)
DRILL HOLE
(E-150 ONLY)
ENLARGE HOLE
(E-150 If needed)