Installation Manual

ManualsBrandsCURT ManualsAutomotiveCURT 13067 Black 2" Class 3 Trailer Hitch Receiver for 2007-2014 Ford Edge, 2007-2015 Lincoln MKX

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE ALL FASTENERS ARE TIGHT AND ALL STRUCTURAL COMPONENTS ARE SOUND

CURT Manufacturing Inc. warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective, Curt Manufacturing Inc. may repair or replace

the product at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement

of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.

For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com

MAKE: STYLE:

MIN.60

WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY

WEIGHT CARRYING:

INSTALLATION TIPS: INSTALLATION TIME:

INSTALLATION REQUIRES:

VEHICLE PHOTO:

HITCH ILLUSTRATION:

REPRESENTATIVE PHOTO

MAKE SURE YOUR HITCH MATCHES

LEVEL OF DIFFICULTY:

MODERATE

EASY

MODERATE

HARD

THE INSTALL TIME LISTED IS FOR PROFESSIONAL

INSTALLERS. IF YOU ARE HESITANT TO UNDERTAKE

THIS TASK ON YOUR OWN, CONTACT AN AUTHORIZED

CURT INSTALLER FOR ADDITIONAL ASSISTANCE.

1. BEFORE YOU BEGIN INSTALLATION, READ ALL

INSTRUCTIONS THOROUGHLY.

2. TO EASE INSTALLATION, 2 PEOPLE MAY BE

REQUIRED.

3. USING PROPER TOOLS WILL GREATLY IMPROVE

THE QUALITY OF THE INSTALL AND REDUCE THE

TIME REQUIRED.

4. NEED HELP OR HAVE SOME QUESTIONS?

CALL TECHNICAL SUPPORT AT 800.798.0813

Safety glasses should be

worn at all times while

installing this product

YEARS:

2007-CURRENT

FORD / LINCOLN

MODEL:

EDGE / MKX

CROSSOVER

4,000

400

TRAILER WEIGHT:

TONGUE WEIGHT:

13067 INSTALLATION INSTRUCTIONS

LBS.

4/29/2011

WARNING:

WE RECOMMEND THE USE OF 18050 STABILIZING STRAPS FOR ALL NON-TRAILER

(WHEEL-LESS) LOADS. PLEASE SEE THE CURT CATALOG OR VISIT US ONLINE AT

WWW.CURTMFG.COM FOR FURTHER INFORMATION.

17/32"

DRILL BIT

POWER

DRILL

RATCHET

SCREW

DRIVER

SOCKET

3/4"

8mm

SOCKET

EXTENSION

TORQUE

WRENCH

AVIATION

SHEARS

LOWER EXHAUST

WIRE

FISHWIRE HARDWARE

TRIM HEAT SHIELDS

DRILL HOLE IN FRAME RAILS

FASCIA TRIMMING

REQUIRED ON EDGE

SPORT MODEL

Summary of content (6 pages)

PAGE 1
3067 YEARS: 2007-CURRENT Safety glasses should be worn at all times while installing this product . INSTALLATION INSTRUCTIONS MAKE: FORD / LINCOLN MODEL: EDGE / MKX STYLE: CROSSOVER WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY WEIGHT CARRYING: INSTALLATION TIME: TRAILER WEIGHT: TONGUE WEIGHT: 60 MIN. THE INSTALL TIME LISTED IS FOR PROFESSIONAL INSTALLERS.
PAGE 2
INSTALLATION WALKTHROUGH: Parts List ITEM PART NUMBER QTY 1 4 1/2-13 x 1 1/2 CARRIAGE BOLT 2 6 HFN 1213 HEX FLANGE NUT 3 6 CM-SP19 .250 x 1.25 x 3.00" SQUARE HOLE SPACER 4 2 1/2-13 x 1 3/4 CARRIAGE BOLT 5 2 1_2 FISHWIRE 1/2" FISHWIRE 1 DESCRIPTION 1. Lower exhaust by removing (3) rubber exhaust isolators. Use wire to hold up exhaust to prevent damage to the exhaust tube. 4 3 5 2. Remove heat shield from driver and passenger side of vehicle.
PAGE 3
INSTALLATION WALKTHROUGH: 3. Trim tab off of heat shields and reinstall the heat shields. Do not reinstall the (2) screws that attach the heat shield to the frame rails. 5. Raise hitch into position and secure it with the supplied 1/2" hex flange nuts. REMOVE TAB FROM DRIVER AND PASSENGER SIDE HEAT SHIELD 4. Fishwire 1/2-13 x 1 1/2" carriage bolts and CM-SP19 spacers into position through end of frame rails and out mounting holes. Note: Ford Edge Sport model, require trimming of fascia.
PAGE 4
INSTALLATION WALKTHROUGH: 6. Using the hitch as a template, drill the rear holes through the frame rails. Fishwire 1/2-13 x 1 3/4" carriage bolts and CM-SP19 spacers into position and secure with flange nuts. 8. Raise exhaust back into position. 7. Torque 1/2" hardware to 75 lb-ft. 75 LB-FT For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.
PAGE 5
13067 FORD EDGE / LINCOLN MKX FITS EDGE SPORT WITH FASCIA TRIMMING 1/4/2011 GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: 4,000 LBS. TRAILER WEIGHT & 400 LBS. TONGUE WEIGHT. ***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.*** Parts List ITEM QTY PART NUMBER DESCRIPTION 1 4 1/2-13 x 1 1/2 CARRIAGE BOLT 2 6 HFN 1213 HEX FLANGE NUT 3 6 CM-SP19 .250 x 1.25 x 3.
PAGE 6
13067 FORD EDGE / LINCOLN MKX FITS EDGE SPORT WITH FASCIA TRIMMING 12/28/2010 GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: 4,000 LBS. TRAILER WEIGHT & 400 LBS. TONGUE WEIGHT. ***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.