Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
BOLT,CAR,7/16-14 UNC,1-1/4,GRD8,YZ
10-1028161
WASHER,FLAT,1/2,YZ
30-0013342
NUT,SER-FLANGE,7/16-14 UNC,GRD8,YZ
20-0010363
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ
20-0006224
HHCS,1/2-13 UNC,2,GRD8,YZ
10-102862
5
HHCS,1/2-13 UNC,2-1/2,GRD8,YZ
10-1040226
WASHER,LOCK,1/2,YZ
30-001532
7
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
5,000
500
44
30
6,000
600
13094 92-95 TOYOTA 4RUNNER (W/ 31.5" TIRES)
6/24/2020
1) FOR EASE OF INSTALLATION REMOVE THE SPARE TIRE FROM THE CARRIER.
2) POSITION THE DRIVER'S SIDE MOUNTING PLATE IN THE OPEN PORTION OF THE FRAME RAIL. THE WELD NUT SHOULD
BE TOWARD THE CENTER OF THE VEHICLE.
(For ease of installation, tilt the mounting plate at 45 degrees when positioning in frame.)
3) HOLD THE MOUNTING PLATE IN PLACE AND INSTALL A 2" HEX BOLT WITH LOCK AND FLATWASHER FROM THE OUTSIDE
OF THE FRAME TO THE WELD NUT ON THE MOUNTING PLATE.
4) REPEAT STEPS ONE AND TWO FOR THE PASSENGER SIDE MOUNTING PLATE.
5) BEFORE TIGHTENING THE FRAME BOLTS RAISE THE CROSS MEMBER TO THE MOUNTING PLATES AND INSTALL THE
HARDWARE AS SHOWN.
6) TORQUE THE 1/2" HARDWARE TO 110 FT/LBS. AND THE 7/16" HARDWARE TO 70 FT/LBS.
7) RETURN THE SPARE TIRE TO ITS PROPER LOCATION.
4
2
7
5
3
1
6
6/24/2020
NO DRILLING REQUIRED
REVISION HISTORY
REV DESCRIPTION DATE APPROVED
1 GENERIC INSTRUCTION SHEET 8/22/2007 DWS
2
CHG TO GRADE 8 TORQUE SPECS
10/1/2012
AJP
3
UPDATED HARDWARE DESCRIPTIONS/NUMBERS 6/24/2020 CJW